3MT Direct Collets – Imperial

3MT Direct Collets – Imperial

3 morse taper collets to fit a range of different Warco milling machines.

• Quality, extremely durable milling addons.

• Range of different sizes available.

• Thread for drawbar – 3/8″ Whitworth unless noted differently below.

 

Imperial sizes available

• 3MT 1/8″ (Item No. 4351) 3/8

• 3MT 3/16″ (Item No. 4352) 3/8

• 3MT 1/4″ (Item No. 4335) – Tapped 12mm

• 3MT 5/16″ (Item No. 4353) 3/8

• 3MT 3/8″ (Item No. 4336)- Tapped 12mm

• 3MT 7/16″ (Item No. 4355) 3/8

• 3MT 1/2″ (Item No. 4337)- Tapped 12mm

• 3MT 1/2″ (Item No. 4337M)  – Tapped 12mm.

• 3MT 9/16″ (Item No. 4356) 3/8

• 3MT 5/8″ (Item No. 4338M)  – Tapped 12mm.

• 3MT 3/4″ (Item No. 4358) – Tapped 12mm

 

About direct collets

• These collets are an alternative to the collet chuck system.

• Each direct collet is held by the machine drawbar.

• As the collet is drawn into the quill it firmly clamps around the end mill / slot drill shank.

• Both plain and threaded shank cutters can be used.

• Direct collets do not overhang which allows maximum capacity between the spindle and table.

• Collets can be purchased individually so are an affordable milling tool holder solution.

 

Also available

• 3MT collets in metric sizes